Galvanized Wire Rope Anti Drone Net 6mm | 15x15cm or 50x50cm Aperture Camouflage Field Barrier

Product Overview

This camouflage field barrier is hand woven from 6 mm hot dip galvanized steel wire rope and delivered as foldable 20 m panels. Each panel is produced with one of two apertures: a tight 15x15 cm grid that stops small consumer drones and thrown objects, or an open 50x50 cm grid that trades some interception density for lower weight, faster handling and more coverage per square metre of netting.

Ferrules are crimped at every rope crossing, so the mesh holds its shape under tension and a single damaged cell can be re-laced on site instead of replacing the whole panel. The camouflage coating breaks up the outline of the barrier when it has to stay hard to see from the air, and the open weave lets wind pass through, which keeps post and anchor loads low.

Technical Specifications

How The Two Apertures Are Used

• 15x15 cm: forward positions, trenches and vehicle parks where small FPV and reconnaissance drones must be physically stopped before they reach the asset.
• 50x50 cm: long perimeter runs, overhead courtyard cover and depot fencing where coverage length and handling speed matter more than cell density.
• Mixed layouts: the two apertures share the same edging and lacing detail, so tight and open panels can be laced into one continuous barrier.

Key Advantages

• Passive interception: the net relies on propeller entanglement, so no power supply, radar or radio jammer is needed at the barrier line.
• Galvanized against red rust: 240 g/m2 zinc coating holds up in rain, snow and coastal humidity without the flaking seen on painted low carbon wire.
• Camouflage finish: the subdued coating reduces visual detection from above, which suits positions that should not be mapped.
• Foldable panels: a 20 m panel rolls into a bundle that two workers can carry and hang without lifting equipment.
• Field repairable: spare rope and ferrules re-lace a damaged cell in minutes, keeping the barrier in service.
• Low wind load: the open weave lets air through, so lighter posts and fewer anchors are enough.

Typical Applications

• Field camps, trenches and forward operating positions
• Temporary checkpoints and event security perimeters
• Overhead cover over courtyards, walkways and storage yards
• Depot, warehouse and substation perimeter reinforcement
• Vehicle and equipment parks needing fast deployable cover

Installation

Panels are tensioned between steel posts, existing fences or building anchors with standard turnbuckles, and adjacent panels are laced edge to edge so the load path stays continuous. A two person team typically installs around 200 square metres per day on open ground. No special tools are required beyond lacing needles and cable cutters.

Ordering Information

Send us the aperture, panel width and total coverage you need, and we will confirm the price and delivery schedule.